国产一区二区三区av,国产成A人亚洲精品无码樱花,黑人大屌内射乌克兰美女

公司新聞

水泥撒布車在施工完后該怎么辦？

來源：http://lzqdw.com/ 日期：2021-04-25

水泥撒布車作為一種路面施工機械，我們?cè)谑褂盟臅r(shí)候一定要注意操作規范和保養，這樣才能讓車輛減少故障率，使用年限更久，而且在使用該車的時候，一定要注意清洗。就算有導熱油系統，及時清洗也是為車輛保養的一種好習慣。

As a kind of road construction machinery, we must pay attention to the operation specification and maintenance when using the cement spreader, so as to reduce the failure rate and prolong the service life of the vehicle, and pay attention to the cleaning when using the vehicle. Even if there is a heat transfer oil system, timely cleaning is also a good habit for vehicle maintenance.

那么我們?cè)谑褂密囕v施工完成后，應該怎么辦，下面小編給大家介紹一下用車小知識。

So what should we do after the completion of the construction of using vehicles? Let's introduce the knowledge of using vehicles.

若施工作業完成后，瀝青罐內仍有少量剩余瀝青，可利用排放口予以排放。

If there is still a small amount of residual asphalt in the asphalt tank after the construction is completed, it can be discharged through the discharge port.

若瀝青剩余較多，則可使用強排功能：在強排口連接軟管，打開閥門①及強排閥⑦，然后啟動瀝青泵。

If there is a lot of asphalt left, the forced discharge function can be used: connect the hose at the forced discharge outlet, open valve ① and forced discharge valve ⑦, and then start the asphalt pump.

待瀝青罐內剩余瀝青排盡后，對瀝青泵及管路進行清洗。

After the remaining asphalt in the asphalt tank is discharged, the asphalt pump and pipeline shall be cleaned.

關閉所有閥門，打開高壓空氣沖洗系統球閥，對后噴管進行清洗，使殘余瀝青經噴嘴排出。

Close all valves, open the ball valve of high pressure air flushing system, clean the rear nozzle, and discharge the residual asphalt through the nozzle.

若使用過手噴槍，則關閉手噴槍控制球閥，打開高壓空氣沖洗系統球閥，對手噴槍進行清洗。

If the hand spray gun is used, close the control ball valve of the hand spray gun, open the ball valve of the high pressure air flushing system, and clean the hand spray gun.

在對瀝青泵和管路進行清洗后，必須關閉沖洗系統各球閥。

After cleaning the asphalt pump and pipeline, all ball valves of flushing system must be closed.
水泥撒布車租賃

撒布車在施工作業完成、清理工作實施后，應進行復位。

The spreader should be reset after the completion of construction and cleaning.

關閉所有閥門；

Close all valves;

將后排管折疊，插入插銷固定；

Fold the rear pipe and insert the bolt to fix it;

在后控制臺操作提升氣缸將后排管提升至上限位置，并利用掛鉤將其固定。

Operate the lifting cylinder in the rear console to lift the rear pipe to the upper limit position, and fix it with the hook.

對瀝青軟管進行檢查、復位、防止扭曲；

Check, reset and prevent twist of asphalt hose;

檢查沖洗系統各球閥，并予以關閉；

Check and close all ball valves of flushing system;

檢查減速器是否脫檔，拔叉復位。

Check whether the reducer is out of gear, and pull the fork to reset.

撒布車在使用過程中，應按時進行技術保養，以保證機械正常運行，延長機械的使用壽命。撒布車除底盤部分按《汽車使用說明書》嚴格進行各級技術保養外，還應做好下列工作：

In the process of using the spreader, technical maintenance should be carried out on time to ensure the normal operation of the machine and extend the service life of the machine. In addition to the strict technical maintenance of the chassis according to the vehicle operation manual, the spreader should also do the following work:

檢查取力器、傳動系統工作情況和各螺栓的緊固情況。

Check the working condition of power take-off and transmission system and the tightening condition of bolts.

檢查液壓管道各接頭是否漏油。

Check the hydraulic pipe joints for oil leakage.

檢查液壓油箱油面是否正常。不夠應當及時補充。

Check whether the oil level of hydraulic oil tank is normal. If it is not enough, it should be supplemented in time.

檢查瀝青泵的工作是否正常。

Check whether the asphalt pump works normally.

檢查各閥門和管路連接處是否正常，如有損壞，應更換和維修。

Check whether the connection of valves and pipelines is normal. If there is any damage, it should be replaced and repaired.

檢查進油濾清器是否被瀝青和雜質堵塞。

Check whether the oil inlet filter is blocked by asphalt and impurities.